FG — Gantry-Type Milling Machine | Lucas Precision Skip to main content
New

FG

  • Movable portal, fixed table — Unlike the FP, the workpiece stays clamped on a fixed table while the portal itself travels 7 000-13 000 mm in X.
  • Fixed table to 3 000 x 12 000 mm — Table plate width is 2 000, 2 500 or 3 000 mm and length 6 000, 8 000, 10 000 or 12 000 mm.
  • Same milling headstock as FP — The headstock runs to 5 000 or 6 000 rpm and travels 3 600-4 600 mm horizontally in Y, matching the FP's headstock but fixed on a portal that moves instead of a table.
  • 1 550 mm ram, FERMAT's own heads — The ram strokes up to 1 550 mm in Z; FERMAT's own UHAmi SDHS and PHAmi S heads, and other optional heads, mount on this headstock.

Built by FERMAT in the Czech Republic. Sold and supported from Cleveland, Ohio.

With every new FERMAT machine

  • Warranty
  • Delivery
  • Installation
  • Operator training
  • Financing options
  • Field service

As an importer of FERMAT boring mills, Lucas completely supports all machines throughout the United States. Our field service technicians are factory trained by FERMAT in the Czech Republic.

Technical parameters

Parameter Units inch
Spindle taper ISO 50 / BT 50 / CAT 50 — optional BIG Plus, HSK 100A
Spindle speed (max.) rpm 5 000/6 000
Max. Power Heidenhain or SIEMENS CNC (S1/S6) hp 57.7 / 80.5; 71.1 / 104.5
Max. Torque Heidenhain or SIEMENS CNC (S1/S6) lbf·ft 676/940; 1 173/1 724
X-axis Travel of the Portal in 275.6/354.3/433.1/511.8
Y-axis Horizontal Travel of Headstock in 141.7/161.4/181.1
Z-axis Vertical Travel of Ram in 61
Fixed table plate width in 78.7/98.4/118.1
Fixed table plate length in 236.2/315/393.7/472.4
Rapid Feed X, Y in/min 591
Rapid Feed Z in/min 787

Imperial values are shown where an exact equivalent exists. Parameters without one — spindle taper, power, torque and speeds — keep their original value.

Description

The FG is FERMAT's gantry-type milling machine with a movable portal running over a fixed table, for medium-size and large workpieces that stay clamped in place. The portal travels 7 000-13 000 mm in X, the milling headstock 3 600-4 600 mm horizontally in Y at up to 5 000 or 6 000 rpm, and the ram strokes up to 1 550 mm in Z. The fixed table is available from 2 000 x 6 000 mm up to 3 000 x 12 000 mm. FERMAT's own UHAmi SDHS and PHAmi S heads, plus other milling heads, mount on the same headstock.

Photos

01 / 06
FG

Request a quote

Tell us about your machine and we'll take it from there.