Gantry Heavy — Boring Gantry Machine | Lucas Precision Skip to main content
New

GANTRY HEAVY

  • Boring headstock, 160 mm spindle — The Gantry Heavy carries a boring headstock with the same 160 mm spindle used on FERMAT's floor-type horizontal boring mills.
  • 1 000 mm spindle extension in W — The spindle extends 1 000 mm in the W axis, reaching into the workpiece without repositioning the gantry.
  • 10 000-50 000 mm column travel — Columns cross up to 50 000 mm in X and the headstock covers 6 100 mm in Y, so one machine spans a long line of parts.
  • 4 000 mm floor plates — Workpieces are mounted on 4 000 mm-wide floor plates, machined from multiple sides in one setup.

Built by FERMAT in the Czech Republic. Sold and supported from Cleveland, Ohio.

With every new FERMAT machine

  • Warranty
  • Delivery
  • Installation
  • Operator training
  • Financing options
  • Field service

As an importer of FERMAT boring mills, Lucas completely supports all machines throughout the United States. Our field service technicians are factory trained by FERMAT in the Czech Republic.

Technical parameters

Parameter Units inch
Spindle diameter in 6.30
Spindle taper ISO 50 / BT 50 / CAT 50 — optional BIG Plus, HSK 100A
Spindle speed (max.) rpm 2500
Max. Power Heidenhain or SIEMENS CNC (S1/S6) hp 99.2/122
Max. Torque Heidenhain or SIEMENS CNC (S1/S6) lbf·ft 2 470/3 039
X-axis travel of Columns in 393.7 - 1 968.5
Y-axis travel of Headstock in 240.2
Z-axis travel of Ram in 59.1
Floor plate width in 157.5
Rapid Feed X, Y, Z in/min 787 / 787 / 394

Imperial values are shown where an exact equivalent exists. Parameters without one — spindle taper, power, torque and speeds — keep their original value.

Description

The Gantry Heavy is FERMAT's boring-headstock gantry machine, built to machine large workpieces from multiple sides in a single setup instead of moving the part between machines. The same 160 mm spindle used on FERMAT's floor-type boring mills extends 1 000 mm in the W axis, and the ram travels up to 1 500 mm in Z while the columns cross 10 000-50 000 mm in X and the headstock covers 6 100 mm in Y. Workpieces are set on 4 000 mm-wide floor plates, with a wide range of optional milling heads and accessories.

Photos

01 / 03
GANTRY HEAVY

Request a quote

Tell us about your machine and we'll take it from there.