Gantry Heavy-Duty — 5-Side Gantry Machine | Lucas Precision Skip to main content
New

GANTRY HEAVY-DUTY

  • 'O'-shape columns and crossbeam — Column and crossbeam form an 'O' shape, giving the structure high rigidity and precision under heavy, complex cuts.
  • Machining from 5 sides in one setup — Extra-large workpieces are machined from five sides without repositioning, on the same boring headstock used across the gantry range.
  • Ram travel up to 2 000 mm — Z-axis ram travel reaches 2 000 mm, longer than the Gantry Heavy, with the same 1 000 mm spindle extension in W.
  • Floor plates from 3 to 5 metres wide — Floor plate width is selectable at 3 000, 4 000 or 5 000 mm to match the workpiece.

Built by FERMAT in the Czech Republic. Sold and supported from Cleveland, Ohio.

With every new FERMAT machine

  • Warranty
  • Delivery
  • Installation
  • Operator training
  • Financing options
  • Field service

As an importer of FERMAT boring mills, Lucas completely supports all machines throughout the United States. Our field service technicians are factory trained by FERMAT in the Czech Republic.

Technical parameters

Parameter Units inch
Spindle diameter in 6.30
Spindle taper ISO 50 / BT 50 / CAT 50 — optional BIG Plus, HSK 100A
Spindle speed (max.) rpm 2500
Max. Power Heidenhain or SIEMENS CNC (S1/S6) hp 99.2/122
Max. Torque Heidenhain or SIEMENS CNC (S1/S6) lbf·ft 2 470/3 039
X-axis travel of Columns in 393.7 - 1 968.5
Y-axis travel of Headstock in 228.3/267.7/307.1
Z-axis travel of Ram in 59.1/78.7
W-axis Spindle Travel in 39.4
Floor plate width in 118.1/157.5/196.9
Rapid Feed X, Y in/min 787, 787
Rapid Feed Z in/min 394

Imperial values are shown where an exact equivalent exists. Parameters without one — spindle taper, power, torque and speeds — keep their original value.

Description

The Gantry Heavy Duty is FERMAT's boring-headstock gantry for heavy, complex machining of extra-large workpieces from five sides in a single setup. Columns and crossbeam form an 'O' shape for rigidity, carrying the same 160 mm spindle used on FERMAT's floor-type boring mills with a 1 000 mm W-axis extension. The ram travels up to 2 000 mm in Z, the headstock up to 7 800 mm in Y, and the columns 10 000-50 000 mm in X. Floor plates are available in 3 000, 4 000 or 5 000 mm widths.

Photos

01 / 02
GANTRY HEAVY-DUTY

Request a quote

Tell us about your machine and we'll take it from there.