Electromagnetic Feed and Rapid Traverse 'Slip-Ring' Type Clutch Adjustment Instructions — Lucas Clutch Data | Lucas Precision Skip to main content
Clutch Data

Electromagnetic Feed and Rapid Traverse 'Slip-Ring' Type Clutch Adjustment Instructions

For Models 41B and 42B machines

Lucas used several types and brands of electromagnetic clutches during the production run of these machines. Some clutches were non-adjustable (they were actually self-adjusting). These instructions ONLY apply to adjustable type clutches that are supplied DC electrical power by a 'slip-ring'.

Clutch Adjustment Instructions:

  1. Remove the Main Motor drive belts.
  2. Insert a piece of 0.015 non-magnetic feeler gauge stock between the magnet plate and the magnet body thru the slot in the side of the adjustment ring.
  3. Engage the clutch (apply electrical power).
  4. A properly adjusted clutch will cause a 'light drag' on the feeler gauge stock when it is removed.
  5. If the clutch requires adjustment, remove the power from the clutch.
  6. Loosen the 'pinch-bolt' that is on the adjustment ring.
  7. Rotate the adjustment ring a small amount.
  8. Tighten the 'pinch-bolt' that is on the adjustment ring.
  9. Re-check the air gap as described in steps 2 thru 4.
  10. Repeat as necessary.

These notes come from the Lucas service archive and are provided for reference. For your specific machine, contact our service department with the machine serial number.